![]() So, any tips on how to get the extruder to start on dime?Īnyone with a V2 or V3 able to print an aircraft? What settings did you use?Īlso, is there any way to control the G-Code produced in the slicing? I would be good to have it work the perimeter then alternate through ribs, keeping all the retract hops short, and alternate back to the start again. The PLA doesn't appear for the first 10 to 15mm of extrusion on the leading edge. ![]() I've spent all day tinkering with retract distance, extra distance, speeds and temps but I cant' get the void to close without having loads of strings and globbing.Ī layer finishes at the trailing edge of the wing, retracts the filament and flies back to the leading edge. Then I tried to print a 3dlabprint aircraft and I have voids in the print after a filament retract. I was thinking I had it dialed in fairly well. I just finished building a Rostock Max V3. Fix that and the Rostock Max can do the 3dlabprint planes (using S3D - MatterControl may also work but I'll need to go back and test it). Tl dr - The bowden tube wasn't all the way down.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |